Cart
Showing 121–135 of 170 results
-
Breadboard
Self-Adhesive Proto Shield
- Small soldering area
- All Arduino pins are brought to the top level
- 1 reset button, 1 general use button, and 2 LED circuits can be used directly
- 5 V, GND and Raw pins are exposed as well
- The mini breadboard has 170 tie points
- The breadboard sticks on the prototype shield with its self-adhesive backing
SKU: STEM18012 -
-
-
Consumables
Solar Panel 6V 7x7cm
Solar Panel 7X7 cm | A mini Solar Panel for DIY Project | A mini solar panel Epoxy is made using two-component resin increased to a temperature of 50/60 degrees Celsius. This type of panel is composed of the following layers: Epoxy resin Solar cells PCB board Solar cell sensors are encapsulated in epoxy resin that guarantees protection against.
SKU: STEM18261 -
Sensor
Sound Sensor
- Detectable sound signal size
- Built-in filter-rectifier circuit, DC signal output
- Good sensitivity, built-in amplifier circuit, adjustable gain
- Voltage signal for sound intensity can be obtained by AD conversion
- Analog voltage signal output, signal amplitude VCC/2
- Compatible for Arduino sensor interface
SKU: STEM18095
Adaptor -5V, 2.4A(ERD)
Piezo Big 5 volt-Buzzer
Vibrating Motor
Raspberry Pi 4 4GB RAM 
Pluto 1.2
Wheel (BO Motor)
Cable Tie - 4 inch(100 pcs)
RF Modules Tx & Rx 315 MHz
Continuous Metal Gear Servo 360? (MG995)
Digital Multi Meter
SD Card Reader
Water Pump Module
Hookup Wire
Solderless 830 pin breadboard
Laser Diode Emitter
LDR Module
RGB LEDs(5 pcs )
Node MCU Cable
Safety Gloves Pairs 










