Cart
Showing 121–135 of 170 results
-
Breadboard
Self-Adhesive Proto Shield
- Small soldering area
- All Arduino pins are brought to the top level
- 1 reset button, 1 general use button, and 2 LED circuits can be used directly
- 5 V, GND and Raw pins are exposed as well
- The mini breadboard has 170 tie points
- The breadboard sticks on the prototype shield with its self-adhesive backing
SKU: STEM18012 -
-
-
Consumables
Solar Panel 6V 7x7cm
Solar Panel 7X7 cm | A mini Solar Panel for DIY Project | A mini solar panel Epoxy is made using two-component resin increased to a temperature of 50/60 degrees Celsius. This type of panel is composed of the following layers: Epoxy resin Solar cells PCB board Solar cell sensors are encapsulated in epoxy resin that guarantees protection against.
SKU: STEM18261 -
Sensor
Sound Sensor
- Detectable sound signal size
- Built-in filter-rectifier circuit, DC signal output
- Good sensitivity, built-in amplifier circuit, adjustable gain
- Voltage signal for sound intensity can be obtained by AD conversion
- Analog voltage signal output, signal amplitude VCC/2
- Compatible for Arduino sensor interface
SKU: STEM18095
Raspberry Pi Zero
Robotics DIY Kit- 4 Wheel
Solderless 830 pin breadboard
Yiking Drilling Workstation
ZERO PCB
Male to Male (40 Jumper Wires)
Node MCU Cable
LDR Module
MQ -8 Hydrogen Gas Sensor
Small 5 volt-Buzzer
Yiking Dual Temperature Heat Gun
Raspberry Pi 4 Case
Safety Gloves Pairs
Servo Motor Testor(CCPM 3)
Taparia Bent nose plier
MQ-7 High Sensitivity CO Carbon Monoxide Sensor
IR Sensors Arrary for Line Follwing(5 IR Sensor Array)
Rain Drop Sensor
MQ-6 Liquefied Petroleum Gas Sensor
Taparia Pricision Screw Driver Set
Joy Stick
MQ-4 Methane Natural Gas Sensor
Solderless 400 pin breadboard 








