Cart
Showing 121–135 of 170 results
-
Breadboard
Self-Adhesive Proto Shield
- Small soldering area
- All Arduino pins are brought to the top level
- 1 reset button, 1 general use button, and 2 LED circuits can be used directly
- 5 V, GND and Raw pins are exposed as well
- The mini breadboard has 170 tie points
- The breadboard sticks on the prototype shield with its self-adhesive backing
SKU: STEM18012 -
-
-
Consumables
Solar Panel 6V 7x7cm
Solar Panel 7X7 cm | A mini Solar Panel for DIY Project | A mini solar panel Epoxy is made using two-component resin increased to a temperature of 50/60 degrees Celsius. This type of panel is composed of the following layers: Epoxy resin Solar cells PCB board Solar cell sensors are encapsulated in epoxy resin that guarantees protection against.
SKU: STEM18261 -
Sensor
Sound Sensor
- Detectable sound signal size
- Built-in filter-rectifier circuit, DC signal output
- Good sensitivity, built-in amplifier circuit, adjustable gain
- Voltage signal for sound intensity can be obtained by AD conversion
- Analog voltage signal output, signal amplitude VCC/2
- Compatible for Arduino sensor interface
SKU: STEM18095
Continuous Metal Gear Servo 360? (MG995)
Red LED(10 pcs)
Blue LED(10 pcs)
Ambitech Wrench
Arduino Uno R3 Casing
RASPBERRY PI 3 Model B+
Soldering Helping hand
Voice Recording Module with Loudspeaker
Pulse Rate Heart Sensor
Arduino Uno DIP R3-Compatible (Without Cable)
Cable Tie - 8 inch(100 pcs)
Water Flow Sensor
Soldering Wire 










