Cart
Showing 121–135 of 170 results
-
Breadboard
Self-Adhesive Proto Shield
- Small soldering area
- All Arduino pins are brought to the top level
- 1 reset button, 1 general use button, and 2 LED circuits can be used directly
- 5 V, GND and Raw pins are exposed as well
- The mini breadboard has 170 tie points
- The breadboard sticks on the prototype shield with its self-adhesive backing
SKU: STEM18012 -
-
-
Consumables
Solar Panel 6V 7x7cm
Solar Panel 7X7 cm | A mini Solar Panel for DIY Project | A mini solar panel Epoxy is made using two-component resin increased to a temperature of 50/60 degrees Celsius. This type of panel is composed of the following layers: Epoxy resin Solar cells PCB board Solar cell sensors are encapsulated in epoxy resin that guarantees protection against.
SKU: STEM18261 -
Sensor
Sound Sensor
- Detectable sound signal size
- Built-in filter-rectifier circuit, DC signal output
- Good sensitivity, built-in amplifier circuit, adjustable gain
- Voltage signal for sound intensity can be obtained by AD conversion
- Analog voltage signal output, signal amplitude VCC/2
- Compatible for Arduino sensor interface
SKU: STEM18095
Raspberry Pi Zero
Raspberry Pi 4 4GB RAM
Pluto 1.2
RF Modules Tx & Rx 315 MHz
RGB LEDs(5 pcs )
Plastic Gear Servo Motor SG90
Safety Gloves Pairs
Soldering Helping hand
Soldering Wire
Position Servo Angle based Metal Gear(MG996R)
RFID Reader A-Tags(RC 522)
Pluto X - Programmable Crash Resistant Nano Drone with HD Camera
PNP Transistor - 2N3906(10 pcs)
Owon Digital Oscilloscope
PNP Transistor - BC557(10 pcs)
Resistor Box
Solar Panel 6V 7x7cm
Safety Goggles
Node MCU Cable 









